Sidestand cutout switch

See ELA81319 for rotary switch that was fitted to some models

 This part is available by special order, request a quote

 639542 MG639542

Oil pressure switch

Does not fit models with 2 valves per cylinder. See ENA12640 for replacement crush washer if required.

Discontinued by Guzzi in 2014, superceded by ELA32710, note ELA32710 has a single male spade connector so it will be necessary to modify wiring to connect this switch

 Sorry, this part is no longer available.

 978854 MG978854

Chrome finish plastic horn cover

 Sorry, this part is no longer available.

 31744765 GU31744765 31 74 47 65
 3174 4765 3174.4765 31.74.47.65

Mechanical Bosch voltage regulator

- Nominal current: 25 amps - Nominal voltage: 14V - Length: 120 mm - Width: 70 mm - Height: 80 mm

 This part is available by special order, request a quote

12703805-z 12703805 GU12703805 12 70 38 05
 1270 3805 1270.3805 12.70.38.05

Dizzie rotor arm

 This part is due back in stock soon, call 01484 841395 to reserve yours

 12715431 GU12715431 12 71 54 31
 1271 5431 1271.5431 12.71.54.31

Complete electronic ignition kit containing alternator mounted ignition pickup, fittings and amplifier unit. Works with 12 volt 3 Ohm coils ELA14500 (big twins) and can be used to replace Digiplex on models with Ducati charging systems where the bike is converted to carburettors. This kit is just an ignition system, it will not control fuelling. The pickups for this kit are mounted on the alternator stator. Supplied with instructions in German with wiring diagrams.

2 year warranty on Sachse ignition kits

Once fitted no further adjustment should be necessary. Preloaded with nine ignition curves, two of which are designed for twin plugged bikes. See this link for fitting instructions. Some bikes may need at least one additional spacer to allow enough clearance for alternator cover to fit once pickup is fitted. Note that if you are replacing a Digiplex system you will also need to replace your 'square' coils with higher impedance 12 volt coils e.g. ELA14500

 This part is available by special order, request a quote

Brand new right hand original "Lego" type switchgear and twistgrip with switches for starter and run/kill.
Previously unavailable new and ideal for your restoration project.

Comes with attached 4 pin molex connector, molex pins and rubber boot, ready to be plugged into your standard loom. Twistgrip for standard dual throttle cables.

See ELA17061 and ELA14055 for left hand switches.

 Sorry, this part is no longer available.

Cut out switch, threaded body. Used as sidestand switch on big twins and clutch cut out switch on V7 series small twins and Breva 750

 This part is available by special order, request a quote

 29759150 GU29759150 29 75 91 50
 2975 9150 2975.9150 29.75.91.50

Lambda sensor with 660mm lead

 This part is available by special order, request a quote

 896110 MG896110

Lambda sensor with 325mm lead

 This part is available by special order, request a quote

 584344 MG584344